How To Reset Linksys Velop?

[linksvelopwifi]

To reset Linksys Velop, locate the reset button on the device, typically found on the back or bottom. Press and hold the reset button for 10 seconds using a paperclip or pin until the LED light starts flashing. This indicates that the device is resetting. Once complete, the Velop will return to its factory settings. After resetting, you’ll need to set up the Velop again by following the initial setup process through the Linksys app or web interface. This method is useful if you're facing connection issues or need to start fresh with your network configuration. Reset Linksys Velop for troubleshooting or reconfiguration.